Remember yesterday when I had that random mug rug in the picture with the Pillows?? Well, today I’m going to re-share the tutorial on making the block! Back in July at the Fabric Shop I was working in, we had a Christmas in July celebration and everyone made a block! I decided to make a Christmas Tree block! So in case you missed it….
It’s not a complicated block at all, would you like to try to it?
I started with fat quarters of each of the 4 prints and just a 2.5 inch strip of the solid.
Step 1: Cut out your pieces. You’ll need a 2.5×4 piece for the inside of the tree, an 1×18 strip for the outside of the tree, a 1.5 inch square for the tree trunk, and a 2.5×12.5 inch strip for the ground. For the background you’ll need (2) 4×7 rectangles, a 1.5x 6.75 strip, a 4×6 rectangle and a 7.5×10.75 rectangle.
Step 2. Make the tree. Trim the inside of the tree so the bottom is 2.5 inches wide. Trim the 18 inch strip into a 4 inch piece and (2) 7 inch pieces. Then sew on the bottom piece, then one side and then the other. Lastly, trim the tree. Ha! Trim the tree…
Step 3: Sew the (2) 4×7 pieces onto each side of the tree. Then trim. Start by trimming along the straight edge of the bottom of the tree. Then the sides so that you end up with a 4×5.5 block.
Step 4: Trim a 1.5 inch strip from each of the scrap pieces of the side of the tree.
Step 5: Sew the strips from Step 4 to the tree trunk pieces.
Step 6: Piece the background. Start with sewing on the trunk to the tree. Then add the 1.5×6.75 strip to the left side of the tree. Next sew on the top square, the 4×5.5 piece. Then the large side is to be sewn onto the right side of the tree. And lastly, sew on the ground.
Step 7: Trim to a 12.5 inch square.
And viola! You’re done! Yea! What are you doing to do with yours?